Gallery
  1. From the mast head
  2. Spring in the yard
  3. Installing new Stereo
  4. New Kenwood installed  with remote in cockpit
  5. Kenwood controller
  6. Installing new Espar diesel heater in a 43ft ketch
  7. Espar Diesel controller
  8. New Garmin chart plotter / repeater at inside helm station
  9. New Garmin Chart plotter at helm in NavPod
  10. Garmin Chartplotter
  11. Garmin in NavPod
  12. New Battery monitor system
  13. New dash with New Raymarine NavTouch plotter
  14. My C&C 36 on launch day
  15. Hauling a Passport 47 for winter storage
  16. Jeanneau 42 mast work
  17. Boat Yard in spring
  18. Sailing on Lake St Clair
  19. Isla Azul haul out
  20. Beneteau 45 from the mast head doing mast head work
  21. Winter in the yard
  22. Spring in the yard from a mast head
  23. Sailing on Lake St Clair
  24. Hoist & Yard from Mast Head work
  25. Wiring Espar heater
  26. New Fuse Panel
  27. Ouch !!!
  28. Building new dash panel
  29. Instruments going into new dash panel
  30. New instruments mounted
  31. New instruments & dash being mounted at helm
  32. Job complete
  33. New fuse panel in
  34. Wiring cleaned up for new panel
  35. New exhaust heat riser/mixer manufactured for Atomic four
  36. mounting new exhaust to Atomic four
  37. New exhaust installed
  38. Counter sinking to mount new rotary AC selector switch
  39. Rotary selector mounted to panel
  40. Conections being made for AC feed on Jeanneau 42
  41. I replaced the Teak panel around this port
  42. Replacing all head hose's on a Beneteau 423
  43. Removing all cabinets to run all new hoses
  44. Used 50ft of hose in two heads.  No more smells
  45. Port lights removed to reseal lens's on Pearson 323
  46. disassembling ports to put in new seals. Originals not available
  47. All port frames were polished and re-installed on Pearson 323
  48. Pearson 323 with fixed ports cleaned and mounted
  49. TV installation
  50. TV installed Beneteau 37
  51. TV gain controller for antenna
  52. Our yard from the water
  53. Keel removal
  54. Keel damage from grounding
  55. Keel bolts after removal
  56. Installing Bow Thruster
  57. Bow thruster installation
  58. Bow thurster mounted
  59. Bow thruster
  60. Mounting thruster
  61. Mounted. Needs bottom paint
  62. Fabricating Battery cables
  63. Main disconnect/fuse to thruster
  64. Battery installation and cables to thruster
  65. Thruster electrical installation
  66. Bow Thruster controller going in
  67. Custom radar pole mount fabrication
  68. Radar pole mount
  69. Custom pole mount with GPS
  70. Radar mount finished
  71. Custom mount finished
  72. Spring
  73. Winter
  74. The office
  75. Water front
  76. Office
  77. Our office
  78. Water front
  79. Jack standed
  80. Mast unstepping
  81. Engine removal
  82. Soda Blasting
Hover over any image. Click to pop out and get more informaton on that image